GOT CRUISER? - Toyota Land Cruiser and FJ Cruiser
Off-Road Parts and Apparel
4wd@gotcruiser.com

Products Designs Photos Contact

►Add-A-Leaf Springs - Toyota Land Cruiser 40/60/62 Series

Copyright 2000-14. All rights reserved.
GOT CRUISER? - TOYOTA LAND CRUISER AND FJ CRUISER
Off-Road Parts Accessories and Clothing
GOT CRUISER? and GOT CRUISER? SYMBOL are registered Trademarks
and protected by United States Patent and Trademark Office.

DISCLAIMER:
"TOYOTA", "LAND CRUISER" , 'FJ CRUISER" are registered trademarks of Toyota Motor Corporation.
GOT CRUISER? is not affiliated with, or endorsed, sponsored, or supported by, Toyota Motor Corporation, Toyota Motor Sales, U.S.A., Inc. or any of Toyota's affiliated companies. These terms are used for descriptive purposes only, and not to denote affiliation or connection with Toyota Motor Corporation.

GOT CRUISER? Add-A-Leaf Springs
Toyota Land Cruiser 40, 60 and 62 Series

These GOT CRUISER? Add-A-Leafs are designed to give a mild lift of 1-1/2" or in the case of severely sagging will help to get you back up where you belong. Available in either a short (24") version, or a long (46") version. The short version will tend to be stiffer, and give better support for heavier loads as well as being less expensive, where as the long version will be much softer but will also be more expensive. Sold in pairs, and includes longer center spring pins necessary for installation.

When installing Add-A-Leafs on the rear of a 60 series Land Cruiser, the rear rubber isolation packing and brackets will need to be removed and a "center bolt spacer" will need to be used to locate the axle to the spring. You will need to purchase 2 each part number CBS60 listed below.

***Prices subject to change without notice***
Shipping/handling charges are not included in the cost of parts and will be added when order is shipped
Payment terms: Visa/Mastercard/Discover for U.S.A. orders only.
Other countries - Paypal payment (fees apply)
Item #:
Description
Cost
40412GC
ADD-A-LEAF KIT 40/60/62 SERIES
Early-1990 24-INCH
SOLD IN PAIRS
$45
60412GC
ADD-A-LEAF KIT 40/60/62 SERIES
Early-1990 46-INCH
SOLD IN PAIRS
$65
CBS60
CENTER BOLT SPACER FOR
60 SERIES LAND CRUISER

12/pair


On 60 series Land Cruisers the OEM rear leaf springs are mounted in a captured rubber isolator system. This system should not be reused when mounting aftermarket springs. Problem is the hole on the axle spring perch is much larger than the typical center pin found on a leaf spring. The OEM isolator has a built in spacer to take up this slack and make sure the axle is properly located in relation to the axle.

These bushings fit over the spring center pin and properly locate the rear springs , allowing for proper mounting of the leaf spring to the perch. Sold in pairs.